Skip to main content

Setup Guide

This section explains how to set up the ADA P1 Meter device in a few simple steps.

1. Connecting the Device​

  • Connect the ADA P1 Meter to the smart electricity meter’s RJ12 (P1) port.
  • The device can be powered by:
    • The electricity meter itself (if supported), or
    • Via micro-USB cable using an external 5V power source.

Warning: Never use both RJ12 and USB power at the same time! This can damage the device.

2. First Startup​

  • When the device powers up, the blue LED will blink three short times.
  • It will then automatically launch a Wi-Fi hotspot named okosvillanyora.hu.

3. Configuring Wi-Fi Connection​

  • Connect your phone or computer to the okosvillanyora.hu Wi-Fi network.
    • Password: 12345678
  • The setup page will appear automatically on most devices. If not, open this address in your browser:
    http://192.168.4.1

4. Selecting Your Home Network​

On the setup page:

  1. Select your Wi-Fi network from the list.
  2. Enter your Wi-Fi password.
  3. (If you have a cloud account) Enter your email address and password.
  4. Save the settings.

The device will then automatically reboot and connect to your Wi-Fi network.

5. Verifying the Connection​

  • After connection, the LED will show a steady blue or blinking blue light to indicate data transmission.
  • The device is accessible on your local network at:
    http://okosvillanyora.local:8989

If the .local address doesn’t work, use the IP address from your router’s DHCP client list.

6. Resetting the Device (Optional)​

If you entered incorrect data or want to reconfigure the device:

  1. Press and hold the RESET button for 10 seconds.
  2. The device will reboot into hotspot mode.
  3. You can repeat the configuration steps as described above.

Note​

After setup, the device automatically starts real-time data transmission. The data is available via the web interface, or in JSON/Telegram format for developers.